x2 Authentic Audient EVO 16 Rack Ears
Mounting bolts
How to install the rack mount ears:
1. Use a 3mm allen key (not included) to remove the two screws on either side near the front
of the unit.
2. Position the rack ear so that the four screw holes are in line with the four
holes found on the side of the EVO 16. Refer to the last image above for correct
positioning. Insert the x4 M4 screws into the holes, and tighten until firm.
Repeat the process again for the other rack ear.
3. Remove the rubber feet which are located on the bottom of the EVO 16
using a Pozidriv screwdriver.
Caution regarding placement
It is not advised to run the unit in a rack above or below hot units such as valve outboard and multichannel AD/DA converters without suitable ventilation space around the unit.
We would suggest a space of at least one rack unit above and below the unit. Ensure side air vents are not covered.
Ensure side air vents are not covered. Additionally, do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
